AirSep Onyx, Инструкция по эксплуатации

Страница: 23 / 102

AirSep
®
Corporation
Onyx/Onyx+/Onyx Ultra Instruction Manual 6-1
6.0 System Operation
When you complete installation as described in the previous section, the oxygen
generator is ready for easy start-up and operation.
6.1 Start-up
1) Set the ON/OFF power switch to ON, and wait five minutes to allow the
product oxygen to attain the purity specified in Appendix A of this instruction
manual.
2) Rotate the flowmeter knob counterclockwise to increase flow or clockwise to
decrease flow as required for your application.
3) The flowmeter is calibrated on a percentage scale. For the Onyx, the
flowmeter must be set at 50% level mark and for Onyx+ unit; the flowmeter
must be set at 70% level mark. For Onyx Ultra, set the flowmeter at 90% level
mark. For proper flowrate setting, ensure that top of the ball of the flowmeter
is at the level mark.
4) If your application requires the pressure of the product oxygen to differ from
the pressure specified in Appendix A of this instruction manual, contact the
AirSep CPD Service Department.
Increasing the flow of the product oxygen above the flow
specified in Appendix A of this manual results in reduced
purity of the product oxygen.
On the Onyx, standard
specifications correspond to a reading of 50% at the
flowmeter (Top of the ball of the flowmeter). On the
Onyx+, standard specifications correspond to 70% at the
flowmeter (Top of the ball of the flowmeter). On the Onyx
Ultra, standard specifications correspond to 90% at the
flowmeter (Top of the ball of the flowmeter).
5) Begin oxygen use by your application.
6.2 Operation
The oxygen generator operates automatically after start-up. Monitor the
performance of the oxygen generator at regular intervals to make sure the product
oxygen remains within the specifications (Appendix A) of this instruction manual.
6.3 Shutdown
1) Set the ON/OFF power switch to OFF.