AirSep Onyx, Инструкция по эксплуатации

Страница: 25 / 102

AirSep
®
Corporation
Onyx/Onyx+/Onyx Ultra Instruction Manual 7-1
7.0 Maintenance
The oxygen generator requires little maintenance. Use the following chart as a
guide to perform preventive maintenance at the required intervals.
Interval Maintenance
Every week Clean gross particle filter. (Refer to Section 7.1 — Cleaning the
Gross Particle Filter.)
Every month Make sure product oxygen remains within specifications in Appendix
A of this instruction manual.*
Clean enclosure. (Refer to Section 7.2 — Cleaning the Enclosure.)
* If product oxygen does not meet specifications, refer to Section 8.0 —
Troubleshooting.
7.1 Cleaning the Gross Particle Filter
Clean the gross particle filter on the back of the oxygen generator enclosure every
week, or more frequently if site conditions warrant. A clean filter allows the unit to
cool properly.
Use the following procedure to clean the gross particle filter:
1) Shut down the oxygen generator as described in Section 6.3 — Shutdown.
Do not operate the unit without the gross particle filter in place.
2) Remove the filter, and insert the second filter provided with the unit.
3) Restart the unit as described in Section 6.1 — Start-up.
4) Wash the filter removed from the unit in a solution of soap and warm water.
5) Rinse the filter thoroughly and remove excess water with a soft, absorbent
towel.
6) Allow the filter to dry, and then store it in a clean location. Alternate the clean
filter with the filter on the unit each time you perform this procedure.