Airphx CID 75k, Руководство по установке пользователя

Страница: 13 / 27

13 | Page
10 Installation Procedure
Step by Step Procedure:
In the example below, Threaded anchors are used to mount the CID 75k to drywall.
1. Find a central location for the CID 75k within the treatment area. Be mindful
of any obstructions that may be within the wall.
2. Remove the wall mount section of the Vesa mount that came preinstalled
on the back of the CID 75k. This is done by removing the two Phillips screws
located on the bottom of the bracket as seen in Fig 1.
3. Place the wall section of the mount against the wall.
4. Using a level, level the bracket and mark four of the smaller holes. It does
not matter if you use the four inner or outer holes.
5. The Threaded Anchors are designed to self-drill into drywall using a Phillips
screwdriver. It may be easier to start the anchor if you make a small hole
first using a Scratch Awl.
6. Screw the anchors in all the way until the outer rim of the anchor is flush
with the drywall.
7. Using a Phillips screwdriver, place all four screws through the wall mount
section and then into each anchor. Tighten all four screws until they a snug.
Be certain to use a level during the final tightening process to ensure the
mount is level.
8. Once the mount is secured to the wall, align the section of the mount on the
back of the CID 75k so that it slides down from the top onto the section of
the mount that is mounted on the wall as shown in Fig 2. The CID 75k will
slide down onto the wall mounted section from the top.
9. The installation is complete. The CID 75k can be plugged in and turned on.
LCD Display:
If upon installation the LCD Display is blank, with the unit powered on, please press
the Fault Indicator to initiate display mode.