1
The purpose of this User’s Guide is to allow you to install
and configure your Access Point so that an end node or
another Access
Point (acting as a Repeater) will be able to
register to it. For detailed installation and configuration
procedures, see the AP1200-E/AP2200-E Technical
Reference Manual.
Before You Start
After unpacking the system, make sure the following items
are present and in good condition.
•
Wireless Access Point — 2200 or 1200 series
•
120VAC/60Hz or 90-264VAC/47-63Hz to 12-18VDC
Power Pack
•
Standard 2dB Dipole Antenna
If any item is damaged or missing, contact your Reseller.
Save all shipping and packing material to repack the unit in
the future, should service be required.
Terminology
Root Unit - An Access Point which is located at the top of a
RF Network Tree. The Root Unit is the starting point in the
network and contains information in its Registration Table
regarding all nodes on the network.
Repeater - A Repeater is an Access Point which is used to
extend the radio range of your RF Network. A single Access
Point has a limited RF range. If your system configuration
includes nodes outside this range, you will need to add a
Repeater in order for them to communicate.
