10
Channel
(1200 Series/900MHz Models)
The channel must match that of other nodes on the RF
network. The default channel is the center frequency with
the highest data rate. Since each channel is matched to a
bit rate, changing the channel will also change the bit rate.
Type
Channel
and then type the applicable channel from the
choices shown. See
Appendix D
in the
AP1200-E/AP2200-E
Technical Reference Manual
for more details.
Root Mode
If your Access Point is serving as a repeater (no
connections to the backbone) you should set root mode to
“Off”
as follows:
Type
Configuration-Radio-Root
and then type
“Y”
in response to the argument prompt.
Verifying Registration
Once you have configured your Access Point with the
correct parameters and the end nodes are correctly
configured, RF communication may begin. The Radio
Indicator will flash “
green”
indicating RF data traffic. The
Status Indicator will be
“solid green”
indicating that one or
more nodes have registered to the unit.