3. Operation
3-14
3.6
Operating Procedure
Make sure that all enclosure doors are closed before starting.
3.6.1 Operating Procedure
To start, please follow the procedure below.
<Engine starts>
1.
Make sure that
Three-phase circuit breaker [A] and Single-phase circuit breaker [B]
are [OFF].
2.
Turn the starter switch [C] to [RUN] position, and the glow lamp [D] goes on.
(If water temperature is high, glow lamp will not go on.)
3.
Immediately after the glow lamp distinguishes, turn starter switch [C] fully to the right to start
engine.
4.
Once the engine has started up, leave the engine running to warm up for approximately 5 minutes.
(If operates machine for warming-up at cold time, turn the Engine Speed selector switch [E] to
“HIGH” position after warming-up operation.)
A180752E
W013
Keep the output terminal cover shut and locked whenever the
machine is running. Note that a voltage of several hundred volts
is applied to the output terminal and control board. When opening
the output terminal cover is unavoidable, be careful not to touch
the output terminal. Electric shock or serious injury could result.
E C H
I D G F A B
Go
to
Discount-Equipment.com
to
order
your
parts
