7
Step 2, BIOS Configuration
Due to a fault in some Plug-n-Play BIOS programs,
it happens occasionally that a newly installed
adapter is assigned an Interrupt Number which is
already assigned to another device. In such a case,
the conflict of Interrupt Number will cause faults in
the behavior of both devices. Then it is necessary to
run the CMOS Setup utility, and manually assign a
non-conflicting Interrupt Number.
Step 3, Driver Installation
Before you connect the 10/100Mbps PCI bus Card
to the network, you have to install the network
driver first. The driver for each networking
operating system is under a separate directory. A
HELP.COM file under root directory lists the
information and detailed installation procedure of
all the available drivers.
Step 4, Boot ROM Installation (optional)
The optional Boot ROM device allows you to
connect a diskless workstation to the network.
Perform the following steps to install your Boot
ROM device:
1.
Insert the Boot ROM into the socket on the
Card.
2.
Refer to the installation procedure provided
by networking operating system.
