6
Installation
Installation the 10/100Mbps PCI bus Fast Ethernet
Card requires Hardware installation first, then BIOS
and Software installation.
Step 1, Hardware Installation
1.
Switch off the computer, unplug the power
cord, and remove the computer’s cover.
2.
Select an unused PCI bus-master slot and
remove its protective bracket.
3.
Carefully insert the card and press until all the
edge connectors are firmly seated inside the
slot. Then, screw the card’s bracket securely
into the PC’s chassis.
4.
Attach the Wake-On-LAN cable (optional, for
PCI 2.1 motherboard). If you require
Wake-On-LAN capability, attach one end of
the 3-pin Wake-On-LAN cable to the
connector on the top edge of the card, and the
other end to the “WOL” connector on the
computer’s motherboard. Refer to your
computer’s installation manual to locate this
connector.
5.
Install the bracket screw, which secures the
card to the cinouter chassis.
6.
Replace the computer’s cover and connect the
network cable to newly installed network
card. Reconnect the computer’s power cord
and plug it into the power outlet.
