Airless DP6825, Руководство по эксплуатации

Страница: 10 / 22

DP-airless Page 10 of 22
Setup
1. Prepare the paint according to the
manufacturer
’
s recommendations
This is probably one of the most important steps
toward trouble-free spraying!
Remove any skin that may have formed on the
top of the paint. If necessary, thin the paint.
Finally, strain the paint through a fine nylon mesh
filter bag (available at most paint dealers) to
remove particles that could clog the spray tip
2.
Unscrew tip and guard
assembly from gun.
3. Uncoil hose and
connect one end
to gun. Use two
wrenches to tighten
securely and tightly.
4.
Connect other end of hose to sprayer.
5. Check the hydraulic oil level. Unscrew the
cover 7#, The oil should be 10mm from the top of the
plate. If the oil is low, fill as necessary low viscosity
hydraulic oil (
#46 hydraulic anti-wearing oil );
Install back the 7# cover. [DP6825 / 6830 /
6835: 1.0L (10mm distance to the top level)]
6. Check the electrical service Be sure the
electrical outlet is properly grounded. You can use
up to 100 foot (30m) of 3 wire, extension cord.
Longer extension cords may affect the sprayer
performance. Use more spray hose, not longer
extension cords
7 . Plug in the sprayer. First be sure the ON/OFF
switch is OFF and the pressure control valve is
turned fully counterclockwise. Plug the sprayer into a
grounded outlet that is at least 3 m away from the
spray area to reduce the chance of a spark igniting,
spray vapors or dust particles.
Pressure regulator valve
Clockwise: stronger / Higher pressure
Counter clockwise: weaker / Lower pressure
(For item DP6825 / DP6825B / DP6830 / DP6835 )