Cut out the objects
in
WINGS
(or
“WG”
) section
objects.
WINGS
Cut out the slots for the engines, wing
fairings, and engines. Note that the
precise placement and number of the
slots will vary by aircraft type. For
(A)
and
(C)
slots, simply cut inwards from
the outside and remove the yellow
sections.
For
(B)
slots, either use a razor or
cut from the inside, remove the
yellow sections, and then repair the
cut wing sections with tape on the
interior.
Insert the completed
Wing Fairings
(
WF0
through
WF9
) into the
appropriate slots.
Insert port-side
Wing Fairings
(E)
into
the port-side wing into the
(D)
slots.
Insert the completed
Wing Fairings
(
WF0
through
WF9
) into the
appropriate slots.
Insert port-side
Wing Fairings
(E)
into
the port-side wing into the
(D)
slots.
Non-printed Side
Printed Side
Once completed, set the objects aside until they are needed at a later stage.
4
Paper-based scale model design system Copyright © 2001-2019
—
James Messner / Papier Avion and Airigami
8
