test a small inconspicuous spot before proceeding.
11.
The Extension Hose (11) connects to the Steam Nozzle and is designed to provide
additional freedom to easily reach a variety of spaces. The Jet Nozzle should be
connected to the male end of the Extension Hose
in order to safely focus the flow of
steam.
12.
The Measuring Cup
(12) provides an easy and convenient way to consistently fill the
Boiler with the optimum amount of water (6 oz. / 180 ml.).
Assembling Your Hand Held Steamer
CONNECTING JET NOZZLE
WARNING: DO NOT attempt to connect any accessories while unit is emitting steam. Doing so could
result in burns or other injury.
1. Align Jet Nozzle with Steam Nozzle as shown (FIGURE 1-A). Jet Nozzle should be sideways 90º
counter-clockwise from it
s final position. Guide keys on Jet Nozzle should line up with key
slots on
base of Steam Nozzle (FIGURE 1-B).
FIGURE 1
2. Slide Jet Nozzle onto Steam Nozzle -
guide keys should fit into key slots. Push Jet Nozzle on
as
far as it will go. Rotate Jet Nozzle 90º clockwise, turning it until it will move no further (FIGURE 2).
FIGURE 2
Connecting brushes
NOTE: The Nylon Utility Brush, Brass Utility Brush and Large Brush are all attached in the same
manner. The Nylon Utility Brush is illustrated in FIGURE 3 as an example.
1.
Align Brush with Jet Nozzle as shown. Guide key on back of Brush should line up with key slot
on side of Jet Nozzle tip (FIGURE 3).
2.
Firmly press Brush onto Jet Nozzle (FIGURE 3).
CAUTION: Make sure Brush is pushed as far as possible onto tip to ensure that it is sealed
securely. This will prevent steam leaks and ensure that Brush is not forced off of Jet Nozzle by
steam pressure.
FIGURE 3
KEY SLOTS
GUIDE KEYS
KEY SLOTS
GUIDE KEYS
