PAGE: 2 / 4
Fig.6
Fig.6-a
Fig.6-b
Fig.9
Fig.8
Motor Screw
Blade Holder
Fig.7
Blade Screw
Washer
Blade Holder
Blade
Fig.10
Fig.11
Fig.12
Mounting Plate
Mounting Plate
Peg
Peg
Housing
Housing
Slot
Rotate
Housing
Hook
Thread the fixture wire through lamp
cover and secure it with set screws.
Terminal
Lamp Cover
Lamp Plate
Lamp Cover
Bolt Nut
Stem
Coupling
Small Washer
Lamp Plate Screw
Motor
Set Screw
There are four grommets attached in
the hardware package. Insert the
grommets into the holes in the mounting
bar. Then install the mounting bar onto
the mounting plate using lock nuts and
washers.
Attach the Blade to the Blade Holder
with Washers and Blade Screws.
Repeat for remaining fan blades.
Connect the small wire harness from
lamp cover to the small wire harness
from lamp plate. Connect the large
wire harness from fan fixture to the
large wire harness from lamp plate.
Make sure all connections are secure.
Secure Blade Holders to the Motor
with Motor Screws and washers.
Line up 3 holes in lamp plate with 3
screws on lamp cover, and secure with
small washers and bolt nuts.
Thread the center pull chain through
the stem, making sure the hex nut side
is pointing up. Screw the stem into the
coupling. Adjust the length by moving
the hex nut.
Slide the Housing up over the Motor. Align the Pegs on the Mounting Plate with
the Slots on the Housing
(Fig.6-a)
. Rotate the Housing clockwise to tightly
secure.
Unscrew the lock nuts from the mounting
plate.
Fig.2
Lock Nut
Mounting Plate
Hook
Mounting Plate
Motor
Fig.5
Mounting Bar
Grommet
Washer
Lock Nut
090218
