PAGE: 2 / 4
071009
Fig.14
Fig.14a
Antenna
DIP Switch
Transmitter
Receiver
Fig.13
Tab
Slot
Hanger Bracket
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it locks into position.
Fig.9
Lock Pin
Collar
Screws
Thread the Motor Wires through the
Downrod Stand Cover and Canopy,
as shown. Then thread the wires
through the Hanger Ball.
Fig.10
Fig.11
Hanger
Ball
Canopy
Downrod Stand
Cover
Motor
Wires
Tighten the Ground Wire Screw.
Slide the pin in. Slide the Hanger Ball
up into position.
Fig.12
Tighten the Hanger Ball Screw to the
Downrod.
Hang the fan on Hanger Bracket,
and make sure the slot of Hanger
Ball is snapped into the chip of
Hanger Bracket exactly.
There is a frequency-setter respectively in
the transmitter and receiver. This "DIP
Switch" is a 4 key unit (Fig. 14). All keys
were set at "ON" position in the beginning.
Set the keys to a different code. Make sure
the same numbered keys are switched "ON"
for both DIP Switches (Fig. 14a). Take note
that the "ON" position may have different
orientation in each.
Code example:
1-ON 2-OFF 3-ON 4-OFF
on both DIP Switches.
Fig.15
Move Ground Wires (a), Outlet Box wires (b), and
Motor Wires (c) away from the center of the Hanger
Bracket. Then slide Receiver through Hanger
Bracket as shown, Antenna end first, until it is
centered. Finally, cut Motor Wires (c) to length
needed for connections.
Antenna
Receiver
Hanger
Bracket
a.
b.
c.
