PAGE: 1 / 4
Installation Steps:
071009
INSTALLATION INSTRUCTIONS
IMPORTANT:
Fig.1
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE "INSTALLATION INSTRUCTIONS" ON THE
FOLLOWING PAGES. IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
THIS FAN MUST BE INSTALLED WITH A WALL CONTROL/SWITCH.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 20 lb (9 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Turn OFF the electric power at the
main fuse or circuit breaker box.
Fig.5
Remove the Hanger Ball screw, then
slide the Hanger Ball downwards.
Fig.3
Housing Screw
Top Housing
Motor Wires
Screw Plate
Collar Screw
Remove six Housing Screws and two Collar
Screws. Take care not to drop the screws or
washers into the fan housing. Push the Screw
Plate and the Top Housing upward, and slide
them down the Motor Wiring until they are out
of the way.
Fig.4
Housing Screw
Top Housing
Center Band
Slot
Blade
Blade Screw W/
Rubber Washer
Screw Plate
Insert the Blade through the slot on the Center
Band. Align holes and fasten Blade to the
motor with Blade Screws and rubber washers.
Repeat for remaining Blades. After all Blades
are fastened securely to the motor, restore the
Top Housing and Screw Plate onto the motor
and fasten it with the six Housing Screws.
Lock Pin and take off the Hanger
Pin. Remove the Hanger Ball.
Fig.6
Slide the pin out. Remove the
Ground Wire screw. Remove the
Fig.7
Motor Wires
Downrod
Thread the Motor Wires through the
Downrod.
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
Fig.8
Downrod
Collar
Tighten the hanger bracket to the outlet box with two mounting screws.(
Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.
) Attach the safety cable hook to the ceiling with the dry wall screw and
washer, and make sure the safety cable hook is covered by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
Fig.5.
Fig.2.
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Washer
Safety Cable Hook
Dry Wall Screw
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
