Turn ON the electric circuit at the
main fuse or circuit breaker box.
Attach the glass shade to the glass holder
by aligning studs and slots, then turn it
clockwise until it is locked in place.
Slide the canopy up to ceiling and over
the two canopy screws on hanger
bracket. Rotate canopy clockwise, next,
while holding the canopy with one hand,
slide the canopy cover over the screws
and rotate clockwise until tight.
Note: Adjust the canopy screws as
necessary until the canopy and
canopy cover are snug.
Fig.13
Canopy Screw
Hanger Bracket
Canopy
Canopy Cover
Remove the motor screws from the
fan motor assembly. Secure blade
holders to the motor with motor
screws. (Making sure the blade holder
with “This side up” words is facing upward)
Go to Fig.18 for the next steps.
Insert the blade and decorative
plate into blade holder, then
secure them with blade holder
screws. Repeat to other blades.
(Making sure the blade with
“This side up” words is facing
upward)
Fig.16
Glass Holder
with LED
Module
Fan Motor
Assembly
For LED module replacement only:
Remove one screw from glass holder
for later use, rotate the glass holder till
it can be take off from motor bottom,
remove wire connectors at last. then
take a new glass holder with LED
module ,connect the white (neutral)
wire from the glass holder to white
(neutral) wire from fan motor assembly
with a wire connector, connect the black
(hot) wire from glass holder to blue (hot)
wire from fan motor assembly with a wire
connector.
Fig.17
Glass Holder
Screw
For LED module replacement only:
Push the glass holder upwards until the
fan motor assembly screws insert into the
key hole slot of glass holder then rotate
the glass holder till it fixed on the motor
bottom. Finally, secure the glass holder
to motor bottom with previous screw
which we removed and tighten the other
two fan motor assembly screws.
Glass Shade
Slot
Fig.18
Glass Holder
Stud
Fig.19
Slide Switch
Reverse
Forward
The slide switch on
fan motor assembly
sets
direction of fan rotation. Select the desired
direction of fan rotation. Push the slide switch
left
for " Forward" and right for "Reverse".
Note: Wait for fan to stop before reversing the direction
of blade rotation.
PAGE: 7 / 9
Fig.20
Fig.15
Motor Screw
Fan Motor Assembly
Blade Holder
Decorative Plate
Blade Holder
Blade Holder
Screw
Blade
Fig.14
F A N C O
200116
