PAGE: 6/8
Fig.11
Canopy Screw
Hanger Bracket
Canopy
Canopy Cover
Slide the canopy up to ceiling and over
the two canopy screws on hanger
bracket. Rotate canopy clockwise, next,
while holding the canopy with one hand,
slide the canopy cover over the screws
and rotate counter-clockwise until tight.
Note: Adjust the canopy screws as
necessary until the canopy and canopy
cover are snug.
Fig.9
Hanger Bracket
Hanger Ball
Receiver
1.
4.
5.
6.
2.
3.
Antenna:
DO NOT CUT
OR SPLICE
Make wire connections:
1) The Motor white wire to the white "TO MOTOR N" wire from
Receiver with a wire nut.
2) The Motor black wire to the black "To Motor L" wire from
Receiver with a wire nut.
3) The Motor blue wire to the blue "To Light" wire from Receiver
with a wire nut.
4) The white wire from Outlet Box to the red "AC in N" wire
from Receiver with a wire nut.
5) The black (hot) wire from Outlet Box to the red "AC in L" wire
from Receiver with a wire nut.
6) The ground wire from Outlet Box to the green ground wire
from the Hanger Ball and the green ground wire from the
Hanger Bracket with a wire nut.
Make sure all of wire nuts are connected firmly.
*** Tuck all wire nuts and wires carefully up into the Outlet Box,
EXCEPT antenna, which should remain outside Outlet Box.
Fig.8
Move the Ground Wires (a), Outlet Box wires (b), and Motor
Wires (c) away from the center of the Hanger Bracket. Then slide
Receiver through Hanger Bracket as shown, Antenna end first,
until it is centered. Finally, cut Motor Wires (c) to length needed
for connections.
Antenna
Receiver
Hanger Bracket
a.
b.
c.
Turn ON the electric power at the main
fuse or circuit breaker box.
Fig.14
Axle
Coupler
Loosen the screw from the coupler of
blade set, insert the axle to the blade
set, tighten it with two screws.
Screw
Fig.12
Fig.13
Set Screw
Fan Guard
Fan Fixture Set
unscrew the set screws from the fan fixture
set, attach the fan guard to the fan fixture
set, align the six holes on fan guard with six
holes on fan fixture set, secure it with set
screw.
Hang the safety cable into the ˝
J
˝ hook, tighten the safety cable to the ˝
J
˝
hook
by using the zip-tie.
Safety Cable
˝
J
˝
Hook
Zip-tie
Fig.10
F A N C O
140819
