T-brackets sit horizontally
-
Panels to fill the space between the upper and lower
faces of the wing, to give the fore and aft faces of the
main landing gear bay structure.
E
Cement the wing spars in place, before cementing the wing halves
together.
G
C
Attach the intake fences.
C
Cut out the main landing gear doors in the wing lower surface.
D
Make two sets of main landing gear bay parts. Cut out these parts
from the .080"/2 mm plastic sheet supplied:
-
Packers to let the
F
Cut off and discard each wing tip and attach the resin wingtips as
shown below (left side shown, right side similar).
Fill and sand the joints in the wing assemblies
A
Remove all the flash and feeds from the resin engine parts and
pylons.
B
Assemble the two engines. The bullet on the cast metal fan discs can
be polished if required, before they are glued into the intakes of the
engines.
5
WING ENGINE SUB-ASSEMBLIES
