AIR2G2 AIR2G2-336, Руководство владельца/оператора, Страница: 23 / 63

24
c) Check the compressor oil by loosening the fill cap and you can visually see the oil.
d) Make sure the belts are snug while the motor is OFF. Check the axle oil by checking the marked line in
the plastic clear reservoir FULL WHEN COLD (see illustration below) Use only 20W-50 oil .
e) Belt tension should be checked between ½ hour and 24 hours running at full load. Belt tension should
also be checked periodically and adjusted when necessary.
f) Check for any oil or fuel leaks and rectify
before using machine
2) Check tire pressure every other use . Axle tires
10 psi (0.689 bar) steering tire 15 psi (1.0342 bar).
3)
Before starting the machine,
loosen the three 3
screws (found on each cylinder rod) with a 1/8
”
“ T ” Wrench, which hold the aluminum clamp
rings located in the HOME position . Raise the
aluminum clamp rings to the top of each rod and
tighten. With the beam in a LOCKED position,
push down the rods until they meet the ground.
You will now be able to look at all 3 probe
tips to make sure they are not bent or dull, and
you will be able to check the aeration holes to
make sure they are clear of any debris.
If probe tips are worn or dull, replace immediately
as damage can occur to the probe or cylinder. In
order to replace the probes and/or probe tips,
follow these instructions:
• Loosen the four (4) 7/16” nuts underneath
the cylinders – ONLY LOOSEN. Turn the
cylinder clockwise and lift the cylinder up.
You can now visually see, inspect or
change any or all probes. Set the cylinder
back on the cylinder mount base. Turn the
cylinder counter clockwise and tighten the
four (4) 7/16” nuts. Tighten in a star pattern.
The rods will rise automatically after the motor is
started, and the air pressure builds.