Air-Vac PHS1500, Руководство пользователя

Страница: 11 / 24

PHS1500/4000 User’s Guide
1029.00.902 9
2 Operation
2.0 Setup
2.0.1 Basic Setup
Remove any remaining packing material from the preheater. Insert the power cord into the receptacle in
the rear panel (PHS1500 only).
2.0.2 Cooling Option
If the preheater is equipped with the optional cooling option, connect an air line to the fitting on the rear
panel. This is a standard disconnect fitting. This should be supplied with 70-110 psi clean, dry air. Note
the regulator will be set to a lower pressure and this is what you will see on the pressure gauge. The air
cooling system typically runs at 50 psi.
2.0.3 IR Probe Option
After unpacking the preheater, if equipped with the IR Probe option, attach the mounting bracket to the
rear of the preheater using the 4 screws provided. The IR Probe arm assembly attaches to the bracket
with 2 screws. Connect the Thermocouple Extension Cable to the IR Probe cable and plug into the front
panel jack
If supplied from the factory with this option an offset is programmed into the Board Temperature controller
already. If not, see the Maintenance section for this.
Mounting
Screws