Air Lift 75687, Руководство по установке

Страница: 6 / 16

4
MN-717
Air Lift Performance
PREPARING THE VEHICLE
1. Remove the tonneau cover and floor matting from the trunk compartment. Fold the rear
seats flat.
2. Unclip the plastic tabs on the tie hooks on the floor behind the rear seat. Remove the
bolts underneath the clip and remove deck floor.
3. Remove the foam floor compartments by removing the plastic rivets.
4. Lift up and remove the rear trim piece where the hatch latch is located.
5. Unthread the hex bolt and Phillips screws from the trunk side panels. Pull the plastic
storage hooks from the top of the panels. Carefully pull at the rear of the panel and unclip
as you move forward. The trunk light needs to be unclipped from its connector during
this process. The front of the panel hooks into the joining backseat panel. Rotate the
end of the panel towards the center of the vehicle. The front of the panel should now be
unhooked. Remove the panels from the trunk.
6. Lift the rear of the vehicle with either a hoist or lift-jack in the approved lift points found
in your vehicle owners manual. Once the wheels are off the ground, support the vehicle
with the jack stands.
REMOVING THE SHOCK
1. Disconnect the skid control sensor from the connector. Unthread the bolt from the sensor
wire and remove bracket (fig. 2).
2. Separate the rear stabilizer end links from the stabilizer bar. Support the suspension
arm.
Installing the Air Lift Performance Kit
fig. 2