PRE-FLIGHT ENVIRONMENT CHECK
CHARGING YOUR JET
1.
Push the
ON/OFF
switch on the
bottom of the
jet to the
LEFT
to turn
the jet
OFF
.
2.
Set the Controller/
Charger switch
to
OFF
.
4.
Carefully
push the charge
nozzle all the
way into the jet’s
charge port
located on the
bottom of the jet.
3.
Flip the Charge
Door open to
reveal the
Charge Nozzle.
1
4
3
2
FLYING INSTRUCTIONS
6.
Remove Charge
Nozzle gently
from the jet’s
Charge Port and
close the Charge
Door.
When
launching
the jet, use
partial throttle.
Refrain from
using the
directional
toggle while
launching the jet.
Launch the jet against the wind
and parallel to the ground.
When preparing for take off,
check the direction of the wind.
Always launch your jet against the wind
for the best take off and flight results.
TIP
: The wind will blow against
your face, if you are facing the correct
direction.
5
IMPORTANT CHARGING INFORMATION:
• Before taking your initial flight, charge the jet for a complete charge cycle on your charger.
• Depending upon the length of future play, you will not need to complete a full charge before each flight.
NOTE:
A shortened charge results in a shorter playtime (may take up to 1/2 hour to fully charge).
Charge
Door
6
1. Location – Fly in a large wide-open, grassy location
that is free of buildings, trees, overhead wires, and
other obstructions.
Do not fly near people or animals.
2. Weather –
Fly on mild, sunny days. Do not fly in
electrical storms, rain, sleet, snow or other adverse
weather conditions. Do not fly if the temperature is
below 7°C/45°F. In very cold temperatures, the jet will
become fragile and the engine performance will
decrease.
3. Wind Conditions –
Do not fly in wind. Winds may
overpower the jet and make it difficult to control. In
windy conditions, it may appear as though you have
no control over the jet.
Holes in plug
must align with
pins in jet.
5
5.
Set the Controller/Charger
switch to
ON
. During the
charging process, the
charging LED will turn
ON
.
When the Thunder Strike™
Jet is completely charged,
the charging LED will
turn
OFF
.
Charging
LED
Push the jet’s
ON/OFF switch
to the right to set
the jet to
ON
.
Fully extend
Controller/Charger
antenna.
Push the
Controller/Charger
Switch right to
ON
to start the
jet’s engine.
Power
LED will
turn red.
4
3
1
2
2
