Aiphone JP-DA, Руководство по установке

Страница: 4 / 24

4
English
F
rançais
Español
Neder
lands
Italiano
MOUNTING
①
Removing the
main unit from the
mounting frame
Place " UP" upwards
Remove the main unit.
(Loosen the locking screws.)
Screwdriver
Tighten Loosen
Main unit
Mounting screw × 2 (not included)
Screw shaft: Ø4.1 or less
Slotted head: Ø8.2 or less, 3.0mm or less in height
1-gang box
83.5 mm
(3-5/16")
Mounting frame
Drainage hole
Do not block the holes.
Front panel
Pry off the front panel with
a
fl athead screwdriver.
Flathead
screwdriver
Main unit
<Bottom surface>
③
Mount the main unit on the mounting frame, and fi t
the front panel on.
Removing the front panel
②
JP-DA
* Remove protective fi lm from camera before use.
ABC
Special
screwdriver
Loosen
Tighten
Vandal-resistant front panel
75 mm
(3'')
150 mm
(5-15/16'')
Drainage hole
Do not block the holes.
Insert
transparent
nameplate here.
Using the transparent nameplates
Inserting the transparent nameplates
①
Remove the vandal-resistant front panel.
② Peel off the protective seals on the plate (both sides).
③
Fill in the name of the resident on the transparent nameplate.
Be sure to leave 25 mm (1") of white space on the right end to
account for insertion.
④ Insert the fi lled-in transparent nameplate at the specifi ed insertion
opening (indicated with in diagram) as below.
25 mm
(1")
2 mm (1/8")
JP-DV
Mounting screw × 4 (not included)
Screw shaft: Ø4.1 or less
Slotted head: Ø8.2 or less, 3.0mm or less in height
Anchor × 4 (not included)
(Prepare anchors according to the
size of the mounting screws.)
(The diameter and the depth of the
holes on the wall depend on the anchors
suitable for the mounting screws used.)
* Remove protective fi lm from camera before use.
ABC
Hexagonal
wrench
Tighten
Special
screw
×
4
Vandal-resistant front panel
Flush mount back box (included)
Transparent nameplate
110 mm
(4-3/8'')
180 mm
(7-3/32'')
45 mm
(1-25/32'')
Using the transparent nameplates
Inserting the transparent nameplates
① Remove the vandal-resistant front panel from the fl ush mount back
box.
② Peel off the protective seals on the plate (both sides).
③
Fill in the name of the resident on the transparent nameplate.
Be sure to leave 25 mm (1") of white space on the right end to
account for insertion.
④ Insert the fi lled-in transparent nameplate at the specifi ed insertion
opening on the rear side of the vandal-resistant front panel (indicated
with in diagram).
25 mm
(1")
2 mm (1/8")
JP-DVF