DEIMOS GERMANIUM FUZZ
17
GERMANIUM TRANSISTORS: INTRODUCTION
Next are the germanium transistors. These are very different than modern electronic
components, so they need an introduction before we cover how to install them.
Silicon vs. germanium
Compared to silicon, germanium transistors are imprecise and inconsistent, even among the
same part number. As a result, when classic fuzz circuits use germanium transistors, it’s not the
part number that’s important, but the specifications of the individual device. Two transistors of
different part numbers with identical gain and leakage will sound exactly the same. Conversely,
not all transistors of the same part number will work in a particular circuit.
Because of this, be aware that this kit may include any of several different part numbers. In this
document we will refer to them as Q1-Q3, not by specific part numbers such as AC125.
Matching
The transistors included in the Deimos kit have been measured and matched for best performance in
the Tone Bender circuit. There are three bags labeled Q1, Q2 and Q3.
It is extremely important that the transistors are not removed from the bags
until it’s time to
install them, and only one at a time, to avoid inadvertently mixing them up. They are not visually
distinguishable from each other, and outside of the bags there is no way to tell which is which. The pedal
won’t sound right if the transistors are used in the wrong positions.
Temperature sensitivity
Germanium is a delicate semiconductor material and very sensitive to overheating. If the transistor is
overheated, it could be permanently damaged. It’s recommended to mount the transistors so they are
elevated above the PCB by about 3/8” (9.5mm) to allow some of the heat to dissipate before it reaches
the body of the transistor. If it takes longer than two seconds for the solder to form a good joint, move to
a different component and let the transistor cool a bit before trying again.
Old-stock precautions
Germanium transistors are not manufactured today except for some expensive industry-specific
applications, so nearly all of the germanium transistors used in guitar pedals are old-stock. The
transistors in this kit are 40 to 50 years old, sometimes even older.
While age has nothing to do with performance of the device itself, the leads may be corroded and solder
may not adhere well unless they are cleaned first. If you notice any corrosion on the leads, use medium-
grit sandpaper or a fine metal file to remove it, and ensure the leads are shiny before soldering.
