AIMIX MD-16E, Справочное руководство

Страница: 35 / 64

- 25 -
UG-MD16E-EN (V1.3-190708)
MD-16E
Mixer Reference manual
[Step 4]:
Repeat step 3 until all routing settings are complete.
[Step 5]: Set the volume of the current output bus in 13 .
[Step 6]: At this point, the routing settings have been completed. Click the bus area on the left side of the
APP screen and select [OFF] to exit the route setting status. Or click the bus button on the panel
to exit the routing settings state.
The structure of the signal access point is as follows.
According to the needs of different output buses, make independent selection of the input signal source.
For example, if AUX1 needs to retain the original signal of input channel CH01, then the access point is
selected as [
Pre-All ] (before all processing units). AUX2 wants input channel CH01 to be processed by EQ,
but do not compress the processing, then the access point is selected as [Pre-Dyn] (before the compressor).
SUB1 is expected to be processed by the compressor, but it cannot be affected by the volume of the input
channel. Then the access point is selected as [Pre-fdr] (before the fader). SUB2 wants to have all the
processing, and is controlled by the input channel volume and DCA, then the access point is selected as
[Pst-fdr] (after the fader). The above is just an example. Each output bus can individually select different
access points for the same input channel.
05 Routing channel mute switch. When the red light is
on, the input channel route is muted and no signal is
coupled to the bus.
06 The route allocates the gain of this channel in dB.
Change by fader adjustment.
07 Fader gain scale in dB. 08 Route Gain Fader (the fader slider is brown).
Channels that are not brown cannot be set as
routes.
09
Channel lever meter ( pre-fader )
，
unit
：
dBfs
。
take
-20dBfs as standard level U.
10 Each output bus, the corresponding signal access
point of each input source channel can be
independently selected, respectively: [Pre-All],
[Pre-Dyn], [Pre-fader], [Post-fader] a total of four
completely independent signal access points.
11 The channel name bar, which contains the physical
channel numbers CH01, CH02, etc., as well as the
channel name that the user can customize.
12 Channel overview area. The channel of the brown
fader slider is a valid routing source channel,
which can be used as a routing input to adjust
routing parameters.
13 Current channel master control panel, adjustable
gain and mute, etc.
[Pre-All] [Pre-Dyn]
[Pre-Fdr] [Pst-Fdr]