3. Installation, powering and accessories
MXm is powered connecting the 37 pins connection harness you find in the kit to the
vehicle master switch. This way MXm will switch on/off with the vehicle engine.
37 pins connection harness wires to be used are labelled “9-15 VDC” and “GND”.
A said before, AiM MXm features two digital outputs you can turn ON/OFF according
to pre-defined conditions you can set using Race Studio 3 software.
They need the connection of the 4 pins connector included in the kit. Please refer to
MXm pinout you find at the end of this user manual for further information.
CHAPTER 3
CHAPTER 4
10
11
MXm
4. At power on
When switched on MXm shows satellite page.
Here you can see the number of connected satellite (SATS 12 in the image above) as
well as the quality of the signal.
If you are on a track not included in MXm database the system shows the message
“NO NEARBY TRACKS and “Track learning” enables automatically. You can disable it
pressing the related button, that switches to “ENABLE” and you only need to press it
again to enable track learning mode. In this second case the system asks for confir-
mation.
Please refer to “Tracks Management” chapter for further information.
MANUALE MXm 1.00 2018.qxp_Layout 1 01/08/18 15:08 Pagina 11
