RACE STUDIO 3 SOFTWARE
26
27
EVO4S
CHAPTER 10
10.1.6 Output Signals
Push the tab "Output Signals" for managing
EVO4S digital output.
Here you can define the condition to meet and the action to perform. In the example below
Channel4 is a Temperature channel: when Water Temperature is higher than 95°C the digital
output will close the circuit to ground until when the condition is no longer met.
For each payload you can define:
n
ID CAN (Hex)
n
Byte number (DLC): up to 8 bytes
Moreover you can transmit each field coming from Analog, digital, internal channel,
expansions, ECU or GPS Module.
10.1.7 CAN Output
Push the tab "CAN Output" to define a CAN
Stream Output.
WARNING: Please be advised that this function allows you to send messages directly to
your vehicle CAN network. Sending messages that can potentially conflict with the CAN-
bus frame may cause malfunction of your vehicle's safety systems, resulting in personal
injury or death. It is your responsibility to fully understand your vehicles CAN-bus. AiM
cannot be held responsible for any damage or injury caused by misuse of this function.
n
Byte Order: little endian or big endian
n
Frequency: up to 20 Hz
EVO4S.qxp_Layout 1 09/01/17 10:22 Pagina 27
