S E T T I N G D A T E A N D T I M E
1 1
5
Setting date and time
To set the meter’s date and time, you need both push buttons.
To access the red button, remove the sliding cover. See chapter
2.3 Reserve battery.
The consequences of this manual time setting to the meter’s
registers are identical to those of the “Set time” command in the
E700UI program. See E700 Meter Product Description.
1.
First make a short press on the black button (the upper
button, see Figure 1). All display characters appear on
display.
2.
Make a short press on the red button located under the black
one. Date and time appear on the display.
3.
Make another short press on the red button again. The day
starts to blink.
4.
If you want to change the day, make short presses on the
black button until you get the desired day on the display.
When the day is correct, proceed to step 5.
5.
Accept the day by making a short press on the red button.
The month field starts to blink. Change the month the same
way as you changed the day (in step 4). Accept the change
by making a short press on the red button. Proceed to the
next field.
6.
Repeat the above steps until the desired date and time are
blinking on the display.
7.
Accept the changes by making a short press on the red
button. If you do not press the red button, the meter date and
time will not change.
You can immediately re-update the meter’s date and time by
pressing the red button again.
©
Enermet Oy
E700
Manual for Installation and Use v. 6.31
ACTIVE INFORMATION MANAGEMENT
