CAUTION: If a pull seal is installed in the
breather hole, be careful not to pinch the
head of the pull seal. Damage to the pull seal
may allow water to enter the housing,
causing damage to the camera and lens.
2. Tighten the retention screw, making sure it is seated
into the rear cap groove. If the housing needs to be
tamper-resistant, the HS9380TK (purchased separately)
should be installed at this time.
3. Attach the housing to the appropriate mount or pan/tilt
using the instructions provided. According to the
orientation of the housing, the cradle assembly may need
to be rotated. To rotate the cradle assembly (while
mounted), grasp the rear handle and rotate to the
desired position. View the monitor while rotating.
Figure 15 Inserting Cradle Assembly
5.9.2
Cradle Assembly
1. Position the housing vertically and replace the cradle
assembly by applying pressure onto the rear cap until the
retaining ring stops against the housing. (see
Figure 15
).
100 0023 002 AIG 1/10
Printed in U.S.A.
©2010 Aigis Mechtronics
1124 Louise Road, Winston-Salem, NC 27107-5450
Tel: 336.785.7740 Fax: 336.785.7744
Data subject to change without notice
