Aidcall Astra 6000, Руководство по установке

Страница: 10 / 12

Doc No. FM5610 issue B Page 10
7. PANEL SETUP
Still on Touchsafe Pro Master Panel (ID 1), select the Zoned Pagers option…
Go to the Touchsafe Pro Panel with the Astra Pager Transmitter connected, Logon as an Engineer and select
the Paging Setup option…
BEEP CODE TABLE
Astra Beep Code J25 Pager Beep Pattern Scope Pager Beep Pattern
0, 1, 3, 4, 5, 6, 7, 8 6 double beeps 8 double beeps
2 8 triple beeps 8 triple beeps
9 high/low beeps + vibrate 8 four beeps
Enter the Beep Code to choose the beep pattern the Pager will sound for each call type.
Set the Protocol option to Astra/Bluebell .
Select the Beep Codes you want the Pager
to sound from the pull ‐ down boxes
alongside each call type.
Note: only 3 different beep patterns are
available with the Astra option ‐ see the
Beep Code table below.
Set the Re ‐ Paging Delay from the
pull ‐ down box; if an alarm call is not
accepted when this period expires the
Pagers will be notified again.
Press the Save button then Close to exit.
Select a Zone from the pull ‐ down box then
enter the 3 digit Pager ID’s

you want to be
notified during the Day, Night 1 and Night 2
modes in the boxes alongside each call type
group ( Cardiac, Emergency, etc. ).

See “Notes on Pager ID’s” on page 9.
The keypad will be displayed when you click
on a box to enter a pager ID ‐ you may need
to press the 123#? button to select the
numeric keypad.
Press the Save button then Close to exit.