Aichi SP12C, Инструкции по эксплуатации

Страница: 38 / 54

Chapter 8 - Operation
30
M082Q220
Foot switch
fig. 8-10
Except for those listed here, you must step
on the foot switch on the platform while
performing all operations
• Engine start
• Work stop operation
• Using the horn
• Operating the work light (option)
• Operating the head light (option)
3–2 Traveling
Traveling is done using the travel control
lever, the steering switch, and the travel speed
select switch.
06-11
Travel speed select switch
Travel control lever Steering switch
fig. 8-11
WARNING
• If the turntable has been rotated 180
°
,
the traveling direction will be opposite
to the lever movements, so be careful.
Make sure to check the direction of the
arrow on the decal and on the chassis
when traveling.
• Before traveling, make sure that no
person or obstacle is in the traveling
direction.
CAUTION
• When traveling down an incline
where the road's slope is more than
the maximum allowable tilt angle,
fully retract the boom, and make sure
the angle of the boom is under the
horizontal.
• When you start traveling, make sure
to turn the lever gradually, and to start
slowly. It is dangerous to start abruptly.
• Adjust the traveling speed by turning
the travel control lever.
• All persons in the platform must
comply with employer, work area, and
local and national safety regulations
regarding the use of personal protective
equipment. Always use a safety harness
in the platform. Attach the lanyard to
the authorized lanyard anchorage point
provided in the platform.
• Do not change course abruptly.
• When traveling, raise the boom so it is
almost horizontal, make sure you can
see to the front, and make sure you
travel safely.
• When traveling, make sure there is
enough distance between the traveling
surface and bottom of the platform,
or the tip of the boom. If there is not
enough distance, depending on the
unevenness of the traveling surface, the
bottom of the platform or the tip of the
boom may come in contact with the
traveling surface, and may be damaged.
In particular, if the fly jib is attached, fully
raise the fly jib before traveling.