Aichi SP12C, Инструкции по эксплуатации

Страница: 30 / 54

Chapter 6 - Pre-Start Checks
22
WARNING
• Do not move the machine until the
checks related function, etc. specified in
this document have been performed.
• Perform the pre-start checks on firm,
level surface. Begin the checks with the
platform lowered.
• If the pre-start checks reveal any
abnormalities, put an “Out of Order” sign
on the machine, and have it repaired
immediately at the nearest designated
service agent.
If you use the machine without repairing
it, it may cause a serious accident.
• If there is damage, such as cracks, on
the welds of the platform handrail, or on
the handrail pipes, change the handrail
immediately.
• Damage and stains to the decals will
obstruct correct handling. Immediately
remove the stain, or change the decals.
• Make sure to perform the checks with
no load on the platform, because if there
is a load on the platform, the checks will
not be exact.
NOTICE
While the machine is being moved, or
the platform is being raised or lowered,
the motion alarm buzzer produces a
warning sound for personnel to stand
away from the machine.
1. Visual check
1–1 Detailed steps
Step 1
Circle the machine once and check visually
that there are no oil leaks, and no damage to
the decal or to the machine.
Step 2
Check the fuel, engine oil, coolant, and
hydraulic oil levels. Replenish if necessary.
Step 3
Check for cracks, or breaks in the boom,
platform, and other parts. Check for loose
bolts, and open covers.
Step 4
Check that greasing points are lubricated
sufficiently.
Step 5
Check that the decal is not damaged, and is
not dirty.
1–2 Preparation for the function
checks
Step 6
Put the machine in the following state:
– Put the machine on a firm, level surface.
– Platform position: center
– Platform load: 0 kg
– Fly jib angle: parallel to the ground
(only SP14CJ)
– Boom elevation: minimum
– Boom rotation: center of the front or the
rear
Step 7
Start the engine and, idle the engine for
warming up.
Chapter 6
Pre-Start Checks