2. PUTTING INTO SERVICE
1. Connect
transducer
to socket M0 (3); (see Section 4).
2. Ensure the
power supply
is connected via the mains adapter;
(see Sections 3.1, 3.2).
3.
Displaying
the measured values
Select MEASURED VALUE function by pressing the key
M
▲
(2).
Select measuring channels by pressing key
M
▲
, read out the
measured values; (see Section 6.1.1).
4. Connect the
cyclic measured value output
to the printer or to the
computer.
Connect the peripheral device via interface cable to socket A1;
(see Manual, Section 5.2).
On the peripheral device set 9600 bauds, 8 data bits, 1 stop bit, no parity;
(see Section 9.2).
If necessary enter the current date and time-of-day; (see Section 9.1).
Select CYCLE function
´ZY´
by pressing the
FUNCTION
key and program
the cycle; (see Section 6.3.2).
Select the output format in the BAUD RATE function
´BR´
by pressing
the keys
PROG,
▲
..,
PROG, ESC
; (see Section 6.3.3).
Start and stop cyclic measuring point scanning by pressing
the
START/
STOP
key; (see Section 6.3.2).
5.
Evaluating a measuring operation
Select the function MAXWERT
´MH´
or MINWERT
´ML´
by pressing
the
FUNCTION
key and call up the maximum and minimum values;
(see Section 6.1.3).
For the available
options
and the appropriate pin assignment please
see the rating plate located on the bottom of the device !
ALMEMO
®
8390-2
11
Putting into service
