AGT 5580/3 GP160, Руководство пользователя

Страница: 24 / 33

24
Inspection
Remove the air cleaner cover and inspect the filter elements. Clean or replace dirty filter elements.
Always replace damaged filter elements. If equipped with an oil-bath air cleaner (models equipped with
GX160 and GX200 engines), also check the oil level.
Cleaning
Dual-Filter Element Types (models equipped with GP160 and GP200 engines only)
1. Remove the wing nut from the air cleaner cover, and
remove the cover.
2. Remove the wing nut from the air filter, and remove the
filter.
3. Remove the foam filter from the paper filter.
4. Inspect both air filter elements, and replace them if they
are damaged. Always replace the paper air filter
element at the scheduled interval.
5. Clean the air filter elements if they are to be reused.
Paper air filter element: Tap the filter element several
times on a hard surface to remove dirt, or blow
compressed air [not exceeding 207 kPa (2.1 kgf/cm ,
30 psi)] through the filter element from the inside. Never
try to brush off dirt; brushing will force dirt into the
fibers.
Foam air filter element: Clean in warm soapy water,
rinse, and allow to dry thoroughly. Or clean in
non-flammable solvent and allow to dry. Dip the filter
element in clean engine oil, then squeeze out all
excess oil. The engine will smoke when started if too
much oil is left in the foam.
6. Wipe dirt from the inside of the air cleaner case and
cover using a moist rag. Be careful to prevent dirt from
entering the air duct that leads to the carburetor.
7. Place the foam air filter element over the paper element, and reinstall the assembled air filter.
Be sure the gasket is in place beneath the air filter. Tighten the air filter wing nut securely.
8. Install the air cleaner cover, and tighten the wing nut securely.
Oil-Bath Type (models equipped with GX160 and GX200 engines only)
1. Remove the wing nut, and remove
the air cleaner cap and cover.
2. Remove the air filter element from
the cover. Wash the cover and filter
element in warm soapy water, rinse,
and allow to dry thoroughly. Or
clean in non-flammable solvent and
allow to dry.
3. Dip the filter element in clean
engine oil, then squeeze out all
excess oil. The engine will smoke if
too much oil is left in the foam.
4. Empty the used oil from the air
cleaner case, wash out any
accumulated
dirt with
non-flammable solvent, and dry the
case.
5. Fill the air cleaner case to the OIL
LEVEL mark with the same oil that is recommended for the engine.
Oil capacity: 60 cm
3
.
6. Reassemble the air cleaner, and tighten the wing nut securely.