AGT 5580/3 GP160, Руководство пользователя

Страница: 16 / 33

16
Plow function (Fig. 28/29/32)
Fasten the wheel mountings (I) as shown in fig. 28.
•
Grease the tool shaft (3g) and pay attention to the alignment of the mounting hole (3i) (Fig. 3)
when installing the pneumatic wheels (K).
1. Insert the fastening pins large (B6) into the openings and secure them with the split pins.
2. Attach the furrowing tool (J) to the desired height using a fastening pin and split pin (B6) as
shown in fig. 32.
Engine Oil Level Check
Running the engine with a low oil level can cause engine damage. This type of damage is
not covered by the Warranty.
Check the engine oil level with the engine stopped and in a level position.
1. Remove the oil filler cap/dipstick and wipe it clean.
2. Insert the oil filler cap/dipstick into the oil filler neck as shown, but do not screw it in, then
remove it to check the oil level.
3. If the oil level is near or below the lower limit mark on the dipstick, fill with the recommended
oil (see maintenance chapter) to the upper limit mark (bottom edge of the oil fill hole). Do
not overfill.
4. Reinstall the oil filler cap/dipstick.
Add oil to engine air filter (only for models equipped with GX160 and GX200 engines with Oil
Bath Type air filter)
Running the engine with a filter
with low oil level can cause engine
damage. This type of damage is not
covered by the Warranty.
1. Remove the wing nut, and remove
the air cleaner cap and cover.
2. Fill the air cleaner case to the OIL
LEVEL mark with the same oil that
is recommended for the engine
(see maintenance chapter).
Oil capacity: 60 cm
3
.
3. Reassemble the air cleaner, and
tighten the wing nut securely.