AGT 5580/3 GP160, Руководство пользователя

Страница: 21 / 33

21
WARNING - The rotation of the blades causes the motorhoe to move forwards.
WARNING - Move the transporting wheels out of the way (upwards) when using the
machine.
PROHIBITED USE
- Never load the blade by putting a ballast weight on it.
- Never pull the motorhoe over hard surfaces or uneven surfaces such as paving or steps.
-
Do not operate a motorhoe with one hand! Serious injury to the operator, helpers, bystanders, or
any combination of these persons may result from one-handed operation. A motorhoe is intended for
two-handed use .
- Only use the motorhoe in well-ventilated places, do not operate the motorhoe in explosive or
flammable atmospheres or in closed environments. Beware of carbon monoxide poisoning.
- Do not use the machine as a means of traction for accessories (e.g. towing).
GB STOPPING THE ENGINE - TRANSPORTION
CAREFULLY READ THE ENGINE INSTRUCTION MANUAL.
STOPPING THE ENGINE
To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal
conditions, use the following procedure:
1. Set the throttle lever (16a, Fig.16) to idle speed.
2. Set the switch (Fig.39) to OFF.
3. Set the fuel valve to OFF (Fig.38)
WARNING - When the engine is switched off, for safety reasons (especially on sloping
terrain) engage first gear as a parking brake.
In the event that the "OFF" (STOP) position of the switch will not function, pull the choke lever in the
CLOSE position, to stop the engine.
Pre-Operation Checking
WARNING: THE CUTTING ATTACHMENT SHOULD NEVER TURN AT IDLE. Turn the idle
speed screw “T” counter-clockwise to reduce the idle RPM, or contact a Servicing Dealer for
adjustment and discontinue use until the repair is made.
Serious personal injury may result from the cutting attachment turning at idle.
A damaged clutch may cause a cutting attachment to rotate at idle speed and increase the risk of
personal injury from loss of control and from contact with the cutting tool.
TRANSPORTATION
Transportation by pushing -
Start the engine and gently accelerate. The machine will slowly move
forwards on the end of the blade teeth, without damaging the path surface.
However, we recommend that you do not transport in this way on very hard surfaces, e.g. tarmac and
concrete.