Wiring a Pressure Switch or Float Switch
to the Aqua Trac V3.1
Wiring a Pressure Switch or Float Switch:
You can have up to 4 Pressure Switches or Float Switches wired into this unit
This wiring assumes using a Normally Open Pressure Swich or Float Switch.
OFF=Open Connection, and ON=Closed Connection
1.
Connect one wire from the Pressure Switch or Float Switch to the terminal marked
PWR as shown above.
2.
Connect the second wire from the Pressure Switch or Float Switch to the terminal
marked SIG as shown above.
Notes: Repeat steps 1-2 for second Pressure Switch or Float Switch at group 2.
Note: You must make sure the jumpers are set correctly for each sensor installed
before turning power on to this unit – see Page 14 for jumper setting information.
Page 25