Wiring the G2 200psi Pressure Transducer
to the Aqua Trac V3.1
Wiring the AgSense G2 Pressure Transducer:
You can have up to 4 Pressure Transducers wired into this unit.
4.
Connect the Red wire from the Pressure Transducer to the terminal marked PWR as
shown above.
5.
Connect the Black wire from the Pressure Transducer to the terminal marked GND as
shown above.
6.
Connect the White wire from the Pressure Transducer to the terminal marked SIG as
shown above.
Notes: Repeat steps 1-3 for second Pressure Transducer sensor at group 2.
Note: You must make sure the jumpers are set correctly for each sensor installed
before turning power on to this unit – see Page 14 for jumper setting information.
Page 24