Agrowtek Inc. | Technology to Help You Grow
www.agrowtek.com
83 Ambrogio Dr Suite H Gurnee, IL 60031 | 847-380-3009
Weather Transmitter
Wind Speed & Direction
Operation & Installation Manual
Agrowtek’s weather transmitter connects Agrowtek’s anemometer and direction vane to the GrowControl
TM
controller.
The transmitter should be located where the sensor wires enter the building. Mount to a wall in a location where there
is adequate air movement and where the transmitter will not get wet.
Transmitter Installation
1. Mounting the transmitter box
Mount the transmitter in an upright position on a vertical
surface using the two mounting holes.
2. Connecting the sensors
The terminal blocks may be removed for wiring. Connect
the sensor wires according to the label on the transmitter
cover. Ensure connections and wires are tight.
3. Connect the transmitter to the controller
Disconnect the power to the controller. Using the supplied
sensor cable, connect one end to the transmitter and the
other end to the desired sensor port.
4. Mapping & Calibrating
The transmitter may not be factory mapped to the
connected sensor port. See controller manual for mapping
instructions.
Speed sensors do not require calibration. Direction sensors
are calibrated physically (see below.)
IMPORTANT
Disconnect power and read installation and operation instructions before installing or operating.
Wall
mounting
holes
Terminal
block outdoor
temp & light
sensors
Wind Sensor
Terminals
Weather Transmitter
Sensor Cable
(to controller)
UP
NOTE
Mount the transmitter upright on a vertical surface
for optimal cooling performance.
