Agrowtek Inc. | Technology to Help You Grow
www.agrowtek.com
83 Ambrogio Dr Suite H Gurnee, IL 60031 | 847-380-3009
Sensor Installation
The sensors are designed for rugged outdoor use in all seasons. The sensors
include mounting brackets with similar holes. Install the sensors in a location
where they have un-obstructed access to wind such as the peak of a roof or
atop a poll. Ensure the sensors are not blocked by trees, roofs, buildings,
stacks, etc.
The sensors are equipped with 25ft. of outdoor rated cable. If necessary, the
cables may be spliced up to 100 ft. Keep the sensor wires to the transmitter as
short as possible; extend the cable between the transmitter and controller if
necessary. Do not run sensor wires parallel to power wires or other cables.
Wind Vane Calibration
1.
Mount the sensors or determine the mounting orientation.
2.
Turn the vane until the display reads directly North.
3.
Tighten the “lock screw” until it is snug on the vane’s shaft.
4.
Twist the vane until the nose points true North.
5.
Release the lock screw.
This completes the calibration for the wind direction vane. The wind speed anemometer does not require calibration.
Transmitter Wiring Diagram
Warranty:
Agrowtek Inc. warrants that all manufactured products are, to the best of its knowledge, free of defective material and workmanship and warrants the
transmitter electronics and sensors for
2 years
from the date of purchase. This warranty is extended to the original purchaser from the date of receipt. This
warranty does not cover damages from abuse, accidental breakage, or units that have been modified, altered, or installed in a manner other than that which
is specified in the installation instructions. Agrowtek Inc. must be contacted prior to return shipment for a return authorization. No returns will be accepted
without a return authorization. This warranty is applicable only to products that have been properly stored, installed, and maintained per the installation and
operation manual and used for their intended purpose. This limited warranty does not cover products installed in or operated under unusual conditions or
environments including, but not limited to, high humidity or high temperature conditions. The products which have been claimed and comply with the
aforementioned restrictions shall be replaced or repaired at the sole discretion of the Agrowtek Inc. at no charge. This warranty is provided in lieu of all other
warranty provisions, express or implied. It is including but not limited to any implied warranty of fitness or merchantability for a particular purpose and is
limited to the Warranty Period. In no event or circumstance shall Agrowtek Inc. be liable to any third party or the claimant for damages in excess of the price
paid for the product, or for any loss of use, inconvenience, commercial loss, loss of time, lost profits or savings or any other incidental, consequential or
special damages arising out of the use of, or inability to use, the product. This disclaimer is made to the fullest extent allowed by law or regulation and is
specifically made to specify that the liability of Agrowtek Inc. under this limited warranty, or any claimed extension thereof, shall be to replace or repair the
Product or refund the price paid for the Product.
Speed Sensor
(Anemometer)
Outdoor Light
Sensor
Outdoor Air Temperature
Sensor
Direction Sensor
(Wind Vane)
RED
BLK
RED
BLK
WHT
Included aluminum
mounting bracket have
matching mounting holes.
Lock
Screw
North
