STEP 1: Insert funnel stems into filter cuts. Locate
opening in poly grid, and insert funnel/filter through
grid. Locate raised fitting in pot bottom on left of pot
bottom. Insert funnel stem into fitting and push until
you hear a click. Repeat for remaining pots.
STEP 2: Insert plants into the pots, adding soil mix to
fill gaps.
STEP 3: Identify vertical surface. Place mounting rack
against surface and use level to check rack is straight
and level. Mark guide holes with drill bit. Remove rack
and drill guide holes.
When mounting on stucco, siding, shingles or masonry
use small hammer to tap anchors into the guide holes.
When mounting on post,
fence or railing, anchors
unnecessary.
Return rack to surface
and drive in the mounting
screws. Repeat for
remaining racks. Zip ties
(not included) are an
alternative fastener for
fences, posts and railings.
STEP 4:
Your rack is now installed. Line up top of pot rear tabs
lift up the pot to put tabs behind upper bar of frame
area for pot and the hook base on bottom bar. To
remove pots, raise pot up, tilt bottom out lower pot
and remove.
WATERING:
Ideally, nature will provide enough rain to water your
AgroSci™ GardenWall.™ If not, the unit features a
failsafe, easy-to-use watering system:
Pour water into top row
of funnels. Water will
flow through soil and
out the pot bottom into
the next row of funnels.
Keep watering until water
comes from pot bottoms
in lowest row.
© Copyright 2021 AgroSci Inc. All rights reserved
