OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
153
Fig. 178
To disconnect hydraulic connection hoses
•
Stop the tractor in safe conditions, turn off the engine and lower the implement
(mounted).
•
Release the pressure from the hydraulic system.
•
Disconnect hydraulic connection hoses. Push the hose towards the connection and then
pull it back vigorously to release it.
•
Install the corresponding protection covers back on hydraulic connections. Before
installing the covers back in place, clean them thoroughly.
7.9.2
USING ELECTRIC CONNECTIONS
Perform the electrical connection as shown in the figure Fig. 178, first lift the safety door on the
electric connection on the tractor and then insert the electric cable. Disconnection in performed
in reverse order.
Before starting to work, check the functionality of all electrical installations on the implement.
Connections on a tractor with standard equipment, see Fig. 178.
•
7-pin socket behind the driver's seat;
•
3-pin socket on the left side of the driver's seat (1).
WARNING:
Always keep the hydraulic couplings clean and protected with
protection covers.
WARNING:
Before installing the electrical installation of the implement, turn
off the tractor and remove the ignition key from the main switch.
Содержание AGT 106
