38
3.4. REPLACING WEAR RINGS
For the CULTIPLOW 52
The CULTIPLOW 52 is fitted with spring securities designed to retract when the blade accidently
hits an obstacle.
Before each time the machine is used, check that all the joint pins are correctly lubricated and that
the wear rings do not show any signs of abnormal clearance. If they do, replace these wear rings
as follows:
1. Before carrying out any operation, it is essential to rest the CULTIPLOW on stable ground on its
safety stands.
2. This CULTIPLOW has been designed for a specific task. It must always be in perfect working
order and must only be repaired using genuine AGRISEM INTERNATIONAL spare parts.
3. Check that the spring is not compressed and that the safety arm is in horizontal position at rest.
4. Check that the locking pin No. 11 is in place. If it is not, you must consult AGRISEM
INTERNATIONAL before carrying out any operation in order to decide the correct procedure to
adopt.
5. Replace the safety parts one by one and not all at the same time to avoid unbalancing the
CULTIPLOW during the operation.
6. If points 1 to 5 have been checked, proceed as follows for dismantling:
a) Remove the 4 bolts (7)
b) Remove the screw ( 4) and the washer (10) and remove the pin (6)
c)
You can now remove the ‘complete shock absorber (5).
d) Remove the screw ( 4) and the washer ( 10) and remove the pin (3)
e) You can now remove the blade arm (2)
7. Changing friction rings
a) Remove the friction rings (8) from their seating
b) Clean the inside of the seatings and then apply a thin layer of grease inside to facilitate fitting
the friction rings.
c) Fit new genuine AGRISEM INTERNATIONAL friction rings.
8. Remounting the assembly.
a) Refit the blade arm (2) then refit the pin (3)
b) Tighten the screw ( 4) and the washer ( 10
c) Refit the complete shock absorber ( 5) and refit the pin (6)
d) Tighten the screw ( 4) and the washer (10)
e) Refit the 4 bolts (9)
9. Proceed in the same way for the other safety springs.
