Edition 11.98
Power Hoe 6000
19
3. Devices and Operating Elements
1 Latch hub with anchoring bolt
2 Latch hub without anchoring bolt
3 Locking nut
One pair of latch hubs
(assist turning)
Assembly
l
Attach the latch hub (1) together with
anchoring bolt to the hoeing shaft, as
shown in the picture.
l
Attach the latch hub (2) without an-
choring bolt to the opposite shaft end.
l
Attach locking nut (3) and tighten it
(100Nm).
Latch hubs can be adjusted as required
via the levers.
l
Middle position = rigid connection
l
Forward position = Drive and free-
wheeling for forward operation
l
Backward position= Drive and free-
wheeling for reverse operation
Fitting the drive-wheels
The drive-wheels can be fitted to the hubs
in two ways, pointing inside or outside to
give the desired track width.
For full tractive power, mount the wheels
with the pointed parts of lugs pointing in
travelling direction (wheels seen from
above). Fit the ball spring washers with
the ball side pointing to the recess in the
disk wheel.
On new machines and after each wheel
change retighten the wheel bolts and nuts
at 100Nm after the first 2 operating hours,
otherwise retighten each time you
maintain the machine.
Wheel-Weights
Wheel weights are available to improve
traction.
Wheel weight ........... Item no. 3221 011
to be fitted to drive-wheels 5.0-10