6
FIGURE 8
FIGURE 9
FIGURE 10
16.
Place the latch lock lever through the slot in the
tongue. Insert the 5/16" x 4" hex bolt (A) through one
side of the tongue. Assemble a (SEMS) hex nut (G),
the lever and another (SEMS) hex nut (G) onto the
hex bolt. Insert the hex bolt through the opposite side
of the tongue and assemble a 5/16" nylock nut (J)
onto the end of the hex bolt. Tighten so that the hex
bolt can still rotate freely. Tighten the two (SEMS) hex
nuts (G) against each side of the latch lock lever so
that it is centered in the slot. See figure 8.
17.
Hook the
short
end of the spring (O) into the hole in
the latch lock lever. Use the spring puller tool (V) to
hook the
long
end of the spring into the square hole
in the tongue. The spring puller tool (V) can be stored
when finished. See figure 9.
FIGURE 11
3/8" x 1"
HEX BOLT (C)
3/8" NYLOCK
NUT (I)
HITCH
BRACKET
1/8" HAIR
COTTER
PIN (Q)
HITCH PIN (S)
5/16" SEMS NUTS (G)
5/16"
NYLOCK
NUT (J)
LATCH
LOCK
LEVER
5/16" x 4"
HEX BOLT (A)
LATCH LOCK LEVER
18.
Assemble the end of the hitch bracket (two holes) up
through the slot at the front of the drawbar tongue.
Fasten it to the tongue using the 3/8" x 1" hex bolt (C)
and 3/8" nylock nut (I).
Tighten.
See figure 10.
19.
Assemble the hitch pin (S) through the hitch bracket
and the tongue and secure it with the 1/8" hair cotter
pin (Q). See figure 10.
20.
Assemble a 1" thin washer (M), a walking beam and
another 1" thin washer (M) onto the pivot axle. Insert
a cotter pin (P) into the axle and spread the ends.
Press a hub cap (W) onto the flat washer. Repeat on
the other end of the pivot axle. See figure 11.
NOTE:
Eight extra 1" flat washers are provided to take up
end play if necessary.
LONG END
OF SPRING (O)
LATCH LOCK LEVER
SPRING PULLER
TOOL (V)
WALKING BEAM
1/8" x 1-1/2"
COTTER PIN (P)
1" THIN WASHER (M)
HUB CAP (W)
