32
BE-BX42S / BE-WC62G USER MANUAL
Unplugging
Although the machine is designed to handle a wide
variety of material without any problem, occasionally it
plugs.
When the machine plugs, follow this procedure to
unplug:
• Clear the area of bystanders, especially small children.
• Stop the engine, remove ignition key, place in pocket
and wait for all moving parts to come to a stop before
unplugging.
• Pull the material out of the feed hopper or reverse the
hydraulic feed hopper. Be sure all the material is out
and nothing is jammed or wedged between the input
opening and the rotor.
• Pull the material out of the discharge hood. Use a stick
to poke loose any material jammed into the discharge
hood. Do not allow anything to remain in this area.
Sever Plug
• Loosen the feed hopper anchor nuts and raise the
feed hopper. Remove material from inside the rotor
compartment.
• Clean out the discharge area/rotor.
• Open the rotor cover and clean out the housing.
Turn the rotor by hand to be sure there is nothing
jammed between the rotor and stationary blades.
• Close, install and fold down all components to unplug.
Tighten fasteners to their specified torque.
• Check that everyone is clear of machine before
restarting engine.
• Start engine, engage PTO and resume working.
WARNING
Machine is shown with guard opened or rotor cover
opened for illustrative purposes only. Do no t operate
machine with guard opened or cover opened
UNPLUGGING
BE-BX42S / BE-WC62G
Unplugging
Although the machine is designed to handle a wide variety
of material without any problem, occasionally it plugs.
When the machine plugs, follow this procedure to unplug:
• Clear the area of bystanders, especially small children.
• Stop the engine, remove ignition key, place in pocket
and wait for all moving parts to come to a stop before
unplugging.
• Pull the material out of the feed hopper or reverse the
hydraulic feed hopper. Be sure all the material is out
and nothing is jammed or wedged between the input
opening and the rotor.
• Pull the material out of the discharge hood. Use a stick to
poke loose any material jammed into the discharge hood.
Do not allow anything to remain in this area.
Sever Plug
• Loosen the feed hopper anchor nuts and raise the
feed hopper. Remove material from inside the rotor
compartment.
• Clean out the discharge area/rotor.
• Open the rotor cover and clean out the housing.
Turn the rotor by hand to be sure there is nothing jammed
between the rotor and stationary blades.
• Close, install and fold down all components to unplug.
Tighten fasteners to their specified torque.
• Check that everyone is clear of machine before
restarting engine.
• Start engine, engage PTO and resume working.
WARNING
Machine is shown with guard
opened or rotor cover opened
for illustrative purposes only.
Do not operate machine with
guard opened or cover opened.
Feed Hopper
Discharge Hood
Rotor Cover
Fig. 29
