9
distance from the edge.
To mount, insert the Parallel Guide into the slot in
the Base Plate and tighten the Thumb Knobs at the
desired position. See fig. 7.
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the
same as that shown on the specification plate of
the machine and that switch is “OFF” before
connecting the tool to the power circuit
Switching the machine on and off
Keep the machine steady during switching and
during use by holding the main handle and the
secondary handle with both hands. See fig. 8.
To switch on:
This machine is equipped with a "LOCK-OFF"
switch. To press the switch, you must first press the
release button located at the top of the switch.
Then the trigger switch will be free to be pressed
to start the machine.
To switch off:
Release the trigger switch to stop the machine.
After the machine has been switched off, the blade
will still rotate for a time, take care that parts of
your body do not come into contact with the blade
while it is still rotating !
ELECTRONIC OVERLOAD PROTECTION
If while cutting the machine reaches a load
approaching overload level, the electronic
overload protection will kick in and shut the saw
off. When this happens, release the trigger and
return the machine to its topmost position (out of
the cut) and wait at least 3 seconds before
continuing.
HOW TO USE THE TOOL
Effective control of this powerful saw requires
two-
handed
operation for maximum protection. Note
there is a secondary handle as well as a side handle
which has two choices of position. Choose the
handle according to the working conditions.
Support the work properly and to hold the saw
firmly
WITH BOTH HANDS
to prevent loss of
control which could cause personal injury. Always
hold one of the auxiliary handles with the left hand
and the main handle with the right hand for
proper hand support of the saw. Protect your eyes
from injury with safety glasses or goggles.
Fig.8
Release Button
On/Off trigger switch
Fig.7
Parallel guide