AGP 1100W Electric Beveler model B16, Инструкция по эксплуатации

Страница: 10 / 24

5. Replace and adjust the support deck
assembly.
Tool holder
Hook spanner
wrench
Open-end
wrench
CHANGING THE INDEXABLE CARBIDE
INSERTS
- DISCONNECT TOOL FROM
POWER SOURCE.
For 1100W Electric Beveler AC
Induction Motor Mode
1. Loosen the 2 Depth Adjustment Screw
and fully unscrew and remove the
support deck assembly.
2. Using the supplied M32 combination
wrench to secure the spindle.
3. Using the supplied 27mm x 24mm
wrench to unscrew the nut in front of
the tool holder and loosen the tool
holder from spindle.
4. Rotate, remove or replace the tool
holders as needed.
5. Using the supplied M3 Hex wrench,
loosen fixing screw and remove the
carbide inserts.
6. Rearrange the carbide insert to the
other sharp edge or insert a new one
as needed.
7. Fasten carbide inserts. glue up the
fixing screws, a suitable adhesive
such as Loctite.
8 . A s s e m b l y i s t h e r e v e r s e o f t h e
disassembly.
Hex. Wrench
LAND WIDTH ADJUSTMENT
The land width of the AC Induction Motor
Mode is factory set to a maximum of
25.4mm, and is continuous adjustable
according to the descriptions below or
descriptions available on the machine.
Depth Adjustment Screw