Page 5 of 8
Version 2
Press button
If the Mode Button (3) is pressed once for less than 5s, the sensor will display all live sensor value in
sequence. Then it will show the min and max of each sensor value since the last reset (using the LO
and HI symbol) Pressing the Mode Button (3) again during this sequence resets the Hi and Lo
values stored on the sensor.
Message
On: Mean sensor is switch On
Off:Sensor is switch Off
OtaP: Sensor is being re-flashed over the air
rst: sensor was reset using the press button (min and max values were reset)
ErrX: display the error message (check list below)
DirE: sensor is going to direct mode (after the button was pressed)
inFr: sensor is going to Infrastructure mode
CHAr: Sensor is off but the USB is connected (Lo symbol means not fully charged and HI symbol
means fully charged)
COnF: Sensor is reconfigured
rOll: Sensor is rolling back to previous stable setting