Agilent Technologies TS-5410, Руководство по подготовке места и установке

Страница: 23 / 30

Test System Installation 23 Chapter 2
3. Locate the power strip’s power connector (Figure 2-2). This is an
IEC320/C19 connector.
Note
Some systems are shipped with an unterminated power cord. Wiring
information for this cord is shown in Figure 2-3.
Figure 2-1. Safety Ground Connections
System Rack
Toothed
Washers
Wire Lug
Earth (ground) terminal
Protective Earth connection at the
AC source where the system AC
power cord is connected
Toothed
Washers
Wire Lug
Bare Wire or Green Wire
with Yellow Stripe
Figure 2-2. Power Strip’s Power Connector