Agilent Technologies N5101A, Руководство по установке

Страница: 6 / 16

6 N5101-90001
Installing the Hardware
PC Hardware and Internal Cables
All Applications:
Power down the PC and disconnect the AC power cable.
Before you install the Baseband Studio PCI card, be sure to note the bar code license number and the model serial
number on the card (described on
page 3 ).
NOTE The N5101A PCI card is a 64-bit card. If you are using the streaming application from a hard disk a
64-bit slot is required. Otherwise, a 32-bit slot may be used without loss of functionality.
Single-card Installation:
Internal cabling:
1.
Connect the GPIO bracket ribbon cable to J3 on the PCI card. The remaining cables can be connected, as shown,
either before or after you install the PCI card in the computer.
2.
For PCI compliant computer cases, install the N5101A PCI card and GPIO bracket using two PCI slots in the PC.
Refer to the PC’s documentation for specific installation instructions.
Number on
GPIO Bracket
PCI Card
Connector
4 J10
5 J11
6 J12
7 J3
8 J13
Caution: Use standard
precautions to protect
against electrostatic
discharge when handling
the PCI card.
J3
J10
J12
J11
J13
Ribbon
Cable
Numbers on
GPIO Bracket
4
5
6
7
8
SMB-to-MCX Cables
For connector visibility, the PCI card
is shown without its metal shielding.
PC Rear
Panel
N5101A PCI Card
GPIO Bracket
N5101A PCI Card